Trigs et Cvs - Claviers & pianos

A-167 is a module that compares analog voltages and derives a gate signal. The state of the gate output (low/high) depends upon which of the voltages is higher. It is possible to compare two external voltages (+In and -In) or an external voltage (+In or -...

Module A-148 (Dual S&H) has two identical sample & hold modules, designed to produce 'staircase' voltages. The signal present at the sample input is sampled at a rate set by the signal at the trigger input, and held at that voltage at the S&H output. The ...

Module A-160 is a frequency divider for clock/trigger/gate signals, designed to be a source of lower frequencies, particularly for rhythm uses. The Trigger input will take clock signals from, eg., an LFO, MIDI sync, or the gate from a MIDI-CV interface. A...

Module A-162 contains two identical circuits that generate a trigger signal with adjustable delay and lenght from an incoming rectangle signal (e.g. gate, trigger, rectangle output of an LFO or VCO). The rising edge of the incoming signal is used to trigg...

Module A-170 contains two separate slew limiters, also known as portamento controllers or integrators. The first SL has just one joint control, which sets both rise and fall times (c. 0 ...10 sec). The second SL has separate controls for rise and fall tim...

Module A-171 (VC Slew Limiter) is a voltage controlled slew limiter, otherwise known as a portamento controller or integrator. It is the voltage controlled versionof the A-170. Whenever there is an abrupt transition in the voltage present at the input, th...

Module A-176 (Control Voltage Source) provides three voltage sources, to use wherever an extra CV is required. The top two voltage sources (CV 1 and CV 2) have controls for coarse and fine control of the voltage output; the third source (CV 3) just has th...